Cu(In, Ga)Se2 (CIGS) thin films have attracted considerable interest as potential photovoltaic solar cells. Moreover, several current studies are focusing on improving their conversion efficiency. This study proposes a method to process micro- and nanostructures onto the surface of CIGS/ITO bilayer films to broaden the field of solar cell application. The bilayer films exhibited optical characteristics different from those of a single-film during processing. Field intensities at different layer positions of the CIGS/ITO bilayer films were analyzed, and different structures were fabricated by varying a set of parameters. Ripples were obtained using a pulse energy of 0.15 μJ and scanning speeds in the range of 0.1-1 mm/s, but after increasing speed to 3-5 mm/s, ripple structures were produced that had a large period of several microns and spatial porous nanostructures. This pattern exhibited low reflectivity. Optimal structures were obtained at a scanning speed of 3.5 mm/s a pulse energy of 0.15 μJ, and a reflectivity lower than 5%. Large areas characterized by micron-sized ripple structures and accompanied by nanoscale porous structures presented high optical performance and efficiency, which can be used to broaden the application of thin film-based solar cells.
Keywords: bilayer films; micro- and nanostructures; porous structures; ripples.