High-density carbon blocks are much lighter than metals and have excellent mechanical properties and are one of the materials garnering attention to replace existing metal parts. In this study, a binderless coke was produced by changing the flow rates of nitrogen and air as a carrier gas during heat treatment of coal tar pitch and using this, a green body was formed at 150 MPa and carbonized to produce a high-density carbon block. We express the binderless coke produced in this way by N10A0, N7A3, N5A5, N3A7, N0A10 according to the ratio of nitrogen and air, and in the case of carbon block, we have added CB in front of it. We then considered the effect of oxygen content in the binderless cokes on the optical, chemical, and mechanical properties. It was observed that the produced binderless cokes develop into a dense mosaic structure with a small particle size as the air flow rate increased. To survey the change in oxygen content of the produced binderless coke, O1s and C1s regions were measured using X-ray photoelectric spectroscopy (XPS), and O1s/C1s was calculated. The O1s/C1s ratio steadily increased as the air flow rate increased, and in the case of N0A10, it increased about twice as much as that of N10A0 to 11.20%. β-resin has a very large effect on the mechanical strength of the carbon block in addition to air in the pitch. And in the case of CB-N0A10, it shows the best mechanical strength with a density of 1.72 g/cm3, bending strength of 87 MPa, and shore hardness of 93 HSD.
Keywords: beta-resin; binderless coke; carbonization; oxygen up-take; swelling.