In the literature, autogenous dentin is considered a possible alternative to bone substitute materials and autologous bone for certain indications. The aim of this proof-of-concept study was to use autogenous dentin for lateral ridge augmentation. In the present retrospective study, autogenous dentin slices were obtained from teeth and used for the reconstruction of lateral ridge defects (tooth-shell technique (TST): 28 patients (15 females, 13 males) with 34 regions and 38 implants). The bone-shell technique (BST) according to Khoury (31 patients (16 females, 15 males) with 32 regions and 41 implants) on autogenous bone served as the control. Implants were placed simultaneously in both cases. Follow-up was made 3 months after implantation. Target parameters during this period were clinical complications, horizontal hard tissue loss, osseointegration, and integrity of the buccal lamella. The prosthetic restoration with a fixed denture was carried out after 5 months. The total observation period was 5 months. A total of seven complications occurred. Of these, three implants were affected by wound dehiscences (TST: 1, BST: 2) and four by inflammations (TST: 0, BST: 4). There were no significant differences between the two groups in terms of the total number of complications. One implant with TST exhibited a horizontal hard tissue loss of 1 mm and one with BST of 0.5 mm. Other implants were not affected by hard tissue loss. There were no significant differences between the two groups. Integrity of the buccal lamella was preserved in all implants. All implants were completely osseointegrated in TST and BST. All implants could be prosthetically restored with a fixed denture 5 months after augmentation. TST showed results comparable to those of the BST. Dentin can therefore serve as an alternative material to avoid bone harvesting procedures and thus reduce postoperative discomfort of patients.
Keywords: autogenous; bone graft; dentin; implant; tooth-shell technique.