Surface tensions at elevated pressure depend strongly on bulk phase saturation

Zachary R Hinton; Nicolas J Alvarez

doi:10.1016/j.jcis.2021.02.114

Surface tensions at elevated pressure depend strongly on bulk phase saturation

J Colloid Interface Sci. 2021 Jul 15:594:681-689. doi: 10.1016/j.jcis.2021.02.114. Epub 2021 Mar 8.

Authors

Zachary R Hinton¹, Nicolas J Alvarez²

Affiliations

¹ Drexel University, Department of Chemical and Biological Engineering, Drexel University, Philadelphia, PA 19104, United States.
² Drexel University, Department of Chemical and Biological Engineering, Drexel University, Philadelphia, PA 19104, United States. Electronic address: nja49@drexel.edu.

PMID: 33780771
DOI: 10.1016/j.jcis.2021.02.114

Abstract

Hypothesis: Understanding interfacial phenomena at elevated pressure is crucial to the design of a variety of processes, modeling important systems, and interpreting interfacial thermodynamics. While many previous studies have offered insight into these areas, current techniques have inherent drawbacks that limit equilibrium measurements.

Experiments: In this work, we adapt the ambient microtensiometer of Alvarez and co-workers into a high pressure microtensiometer (HPMT) capable of experimentally quantifying a wide range of interfacial phenomena at elevated pressures. Particularly, the HPMT uses a microscale spherical interface pinned to the tip of a capillary to directly measure surface tension via the Laplace equation. The stream of microscale bubbles used to pressurize the system ensures quick saturation of the bulk phases prior to conducting measurements. The HPMT is validated by measuring the surface tension of air-water as a function of pressure. We then measure the surface tension of CO₂ vapor and water as a function of pressure, finding lower equilibrium surface tension values than originally reported in the literature.

Findings: This work both introduces further development of a useful experimental technique for probing interfacial phenomena at elevated pressures and demonstrates the importance of establishing bulk equilibrium to measure surface tension. The true equilibrium state of the CO₂-water surface has a lower tension than previously reported. We hypothesize that this discrepancy is likely due to the long diffusion timescales required to ensure saturation of the bulk fluids using traditional tensiometry. Thus we argue that previously reported elevated pressure measurements were performed at non-equilibrium conditions, putting to rest a long standing discrepancy in the literature. Our measurements establish an equilibrium pressure isotherm for the pure CO₂-water surface that will be essential in analyzing surfactant transport at elevated pressures.

Keywords: Carbon dioxide; Elevated pressure; Microtensiometry; Surface tension.