Ultrasonically tuned surface tension and nano-film formation of aqueous ZnO nanofluids

Elif Begum Elcioglu; S M Sohel Murshed

doi:10.1016/j.ultsonch.2020.105424

Ultrasonically tuned surface tension and nano-film formation of aqueous ZnO nanofluids

Ultrason Sonochem. 2021 Apr:72:105424. doi: 10.1016/j.ultsonch.2020.105424. Epub 2020 Dec 24.

Authors

Elif Begum Elcioglu¹, S M Sohel Murshed²

Affiliations

¹ Department of Mechanical Engineering, Faculty of Engineering, Eskisehir Technical University, 26555 Eskisehir, Turkey.
² Center for Innovation, Technology and Policy Research (IN+), Department of Mechanical Engineering, Instituto Superior Técnico, University of Lisbon, 1049-001 Lisbon, Portugal. Electronic address: smurshed@tecnico.ulisboa.pt.

Abstract

Nanofluids' thermophysical properties and heat transfer performance has been investigated for many years, while research on their surface tension (ST) and wetting behavior is very limited. To assess nanofluids potential as industrial products, a complete picture is required to prove their performance in a specific application. Boiling heat transfer, microfluidics and drug development are among the applications where ST is a variable. ST of water-based ZnO nanofluids were measured in the presence and absence of direct ultrasonication. The experiments covered variation of ST with ZnO concentration (0.05-0.4 vol%), ultrasonication amplitude (40% and 100%) and duration. To the best of the authors' knowledge, this is the first report of ST- ultrasonication process relation for a nanofluid. Results showed that after direct ultrasonication, nanofluids ST is strongly affected by the temperature raise, and in those cases relative ST may provide a clearer picture. A nano-film over individual and agglomerated nanoparticles spotted via TEM imaging was affected from the ultrasonication. Such a nano-film can play a key role in the anomalous thermal transport and wettability of nanofluids. Statistical analyses revealed that changes in ultrasonication amplitude resulted in a statistically significance difference on nanofluid ST and relative ST. Changes in nanoparticle concentration caused a significant difference on the nanofluid ST while the difference in relative ST was insignificant. Variation of ultrasonication duration caused significant variations on the relative ST while the difference in nanofluid ST was not significant. This work highlights that based on specific applications ST and other related features of any nanofluid can be adjusted employing proper ultrasonication conditions.

Keywords: Nano-film; Nanofluids; Statistical analysis; Surface tension; Ultrasonication.