The subject of the research is a polymer composite with a matrix base of epoxy resin L285 cured with H285 hardener, and a physical modifier of friction in the form of alundum. The article presents an analysis of findings of tribological examinations. The authors evaluated the influence of the modifier properties in the form of alundum, i.e., mass share and grain size, on the abrasive wear of a composite, defined as loss of weight as well as on roughness parameters and selected mechanical properties. The tribological examinations have been extended by measurements of hardness and density of the prepared composites. The obtained results of tribological examinations showed an increase in the average value of weight loss in relation to the loss of sample weight loss between the cycles. The influence of both the grain size and the mass percentage share of alundum upon the increase in the longitudinal modulus of elasticity was also observed. On the basis of the obtained results, it was found that alundum of grain sizes equal to F220 and F240 exerted the best influence on the reduction of abrasive wear of the tested samples. In the case of F220, it was 14.04% of the average value of the weight loss between the cycles for all percentage shares of the used grains.
Keywords: abrasive wear; alundum; epoxy resin; polymer composites; tribology.