Separation of Zn(II), Cr(III), and Ni(II) Ions Using the Polymer Inclusion Membranes Containing Acetylacetone Derivative as the Carrier

Elzbieta Radzyminska-Lenarcik; Ilona Pyszka; Malgorzata Ulewicz

doi:10.3390/membranes10050088

Separation of Zn(II), Cr(III), and Ni(II) Ions Using the Polymer Inclusion Membranes Containing Acetylacetone Derivative as the Carrier

Membranes (Basel). 2020 Apr 30;10(5):88. doi: 10.3390/membranes10050088.

Authors

Elzbieta Radzyminska-Lenarcik¹, Ilona Pyszka¹, Malgorzata Ulewicz²

Affiliations

¹ Faculty of Chemical Technology and Engineering, UTP University of Science and Technology, Seminaryjna 3, PL 85-326 Bydgoszcz, Poland.
² Faculty of Civil Engineering, Czestochowa University of Technology, Dabrowskiego 69 Street, PL 42-201 Czestochowa, Poland.

Abstract

Polymer inclusion membranes (PIMs) doped with ethylenodiamino-bis-acetylacetone as fixed carrier was applied for the investigation of the facilitated transport of Zn(II), Cr(III), and Ni(II) ions from an aqueous nitrate feed phase (c_M = 0.001 mol/dm³). The optimal membrane composition (amount of carrier and o-NPPE-plasticizer) was determined. For the optimal polymer inclusion membranes doped with ethylenodiamino-bis-acetylacetone, the following patterns of transport selectivity were found: Zn(II) > Cr(III) > Ni(II). The initial flux of Zn(II), Cr(III), and Ni(II) ions was 6.37 µmol/m²∙s, 5.53 µmol/m²∙s, and 0.40 µmol/m²∙s, respectively. The selectivity coefficients equal to 1.2 and 15.9 were found for Zn(II)/Cr(III) and Zn(II)/Ni(II), respectively. After 24-h transport, the recovery factor of Zn(II), Cr(III), and Ni(II) were 90%, 65%, and 6%, respectively. The polymer inclusion membranes doped with ethylenodiamino-bis-acetylacetone were characterized by scanning electron microscopy and non-contact atomic force microscopy. The influence of membrane morphology on transport process was discussed.

Keywords: acetylacetone derivatives; metal separation; polymer inclusion membrane.