We report evidence of a displacive phase transformation from retained austenite to martensite during preparation of quenched and partitioned steel micro-pillars by using a focused ion beam (FIB) technique. The BCC phase produced by the FIB damage was identified as martensite. The invariant-plane strain surface relief associated with the martensitic transformation was observed in the retained austenite phase immediately after a FIB scan of the surface with the Ga+ ion beam. Use of a low acceleration voltage appears to lower the probability of the phase transformation, while a decrease of the acceleration voltage will result in an increase of the total milling time required to prepare a micro-pillar. This report addresses challenges related to the preparation of austenite micro-pillars by a conventional FIB technique.
Keywords: focused ion beam; martensitic transformation; micro-pillar compression; quenched and partitioned steel; retained austenite.