Aims: To evaluate the influence of minor differences in molecular weights of commercially available low molecular weight PLGA grades on the kinetics of doxorubicin release from the nanoparticles.Methods: Three low-molecular weight 50/50 PLGA polymers were thoroughly characterised concerning intrinsic viscosity, molecular weight (Mw), acid value, and residual monomer content. The doxorubicin-loaded nanoparticles prepared using these polymers were evaluated concerning the kinetics of drug release and hydrolytic degradation.Results: The Mw of the polymers were slightly different: 10.2, 10.3, and 4.7 kDa. The nanoparticles obtained from the polymer with Mw of 4.7 kDa exhibited considerably higher rates of drug release and polymer degradation.Conclusion: In the case of low molecular weight PLGA grades even a few kilodaltons could be important for the batch-to-batch reproducibility of the nanoformulation parameters. These results bring forward the importance of in-house characterisation of the polymers to be used for the nanoparticle preparation.
Keywords: PLGA; doxorubicin; hydrolytic degradation; molecular weight; nanoparticles; release rate.