The combination of two microextraction techniques (dispersive liquid-liquid microextraction [DLLME] and magnetic dispersive microsolid phase extraction [MDMSPE]) was developed and reported for atrazine and simazine preconcentration from wastewater samples. The proposal methodology involved the use of magnetite supports functionalized with different alkyl or phenyl groups. The magnetic adsorbents were synthesized by the solvothermal method assisted by microwave, characterized, and used in the sample preconcentration of atrazine and simazine. The method validation included parameters such as the wastewater matrix effect, repeatability, and recovery. The analyte separation and quantification were performed by high-performance liquid chromatography with ultraviolet detection (HPLC-DAD). Parameters, such as the polarity and mass of magnetic solids and pH, were evaluated to provide better extraction performance. The highest recoveries (> 95%) were obtained with 50 mg of the phenyl group support (CS2) at pH 5, using 5 mL of the sample and carbon tetrachloride and methanol, as extraction and dispersive solvents, respectively. The lowest limits of detection (LOD) achieved were 13.16 and 13.86 ng L-1, and the limits of quantification (LOQ) were 43.89 and 46.19 ng L-1 for simazine and atrazine, respectively, with repeatability (expressed as %RSD) below 5% in all cases. The developed method is simple, easy, and low cost for the analysis of two herbicides potentially dangerous for environmental and human health. Graphical abstract.
Keywords: Coupled microextraction techniques; Dispersive liquid-liquid microextraction; Magnetic adsorbents; Magnetic dispersive microsolid phase extraction; Triazines.