Slot die coating has been established as an economical approach for deposition of parallel narrow stripes, a constituent pattern feature in many printed device applications. However, the minimum feature size that can be achieved using this approach is constrained by wetting and liquid bridge phenomena at the deposition region. We hypothesize that pattern resolution and process control can be improved by co-depositing a support fluid to stabilize the pattern. Electrically conductive poly(3,4-ethylenedioxythiophene):polystyrene sulfonate (PEDOT:PSS) is slot die-coated in parallel stripes on flexible poly(ethylene terephthalate) substrate, without wettability-enhancing dopants or substrate pretreatment. A miscible liquid phase, polyvinyl alcohol, is used as the support material. Feature size performance and conductivity of PEDOT:PSS stripe regions are evaluated across a range of process conditions. Narrow PEDOT:PSS stripes produced using our technique range from 400 to 850 μm and exhibit conductivity approaching 1.5 S cm-1. This electrical performance falls within the upper range expected prior to standard conductivity-enhancing post-treatments. Significantly, dewetting effects normally present with undoped PEDOT:PSS on the plastic substrate are fully mitigated with our deposition technique. These results indicate high ease of processing and good feature size performance, with few inherent drawbacks to the functional properties of the patterned films.
Keywords: PEDOT:PSS; feature size; flexible; printed electronics; roll-to-roll; slot die coating.