Ondansetron hydrochloride (ODS) is a selective 5-hydroxytryptamine type 3 antagonist for nausea and emesis prevention in neoplastic patients. To reduce dosing frequency and side effects and improve patient compliance, a sustained release parenteral formulation of ODS was developed. Microparticles of methylcellulose (MC) and ODS were prepared using the spray-drying method and suspended in oils to form oil suspensions. The formulations were evaluated for residual moisture, drug content, size distribution, DSC, XRD, FTIR, SEM, drug release, and pharmacokinetic studies. The effects of polymers and oils on the drug release were evaluated. MC showed the most prominent sustained release effect among various polymers examined with the optimum MC/ODS ratio of 2:1 (w/w). The particle size of the produced microparticles was in the mean diameter of approximately 3 μm. Physicochemical characterization suggested that ODS existed in an amorphous matrix within the microparticles and interacted with MC via hydrogen bonds. Corn oil was selected as the appropriate oil for suspension due to the sustained release of ODS and the appropriate viscosity. The optimized sustained release formulation of ODS was the corn oil suspension of spray-dried microparticles containing MC and ODS (2:1, w/w). It showed an in vitro drug sustained release up to 120 h, while the oil suspension of ODS without any polymer released the drug within 2 h. Following subcutaneous administration in rats, the optimized formulation could prolong the drug release until 72 h with the enhanced bioavailability in comparison with the ODS solution. The oil suspension of spray-dried microparticles might be an efficient approach for prolongation of the drug effect in the management of nausea and emesis. Graphical abstract.
Keywords: Microparticles; Oil suspension; Ondansetron hydrochloride; Parenteral formulation; Spray drying; Sustained release.