Background Some clinical chemistry measurement methods are vulnerable to interference if hemolyzed serum samples are used. The aims of this study were: (1) to obtain updated information about how hemolysis affects clinical chemistry test results on different instrument platforms used in Nordic laboratories, and (2) to obtain data on how test results from hemolyzed samples are reported in Nordic laboratories. Methods Four identical samples containing different degrees of hemolysis were prepared and distributed to 145 laboratories in the Nordic countries. The laboratories were asked to measure the concentration of cell-free hemoglobin (Hb), together with 15 clinical chemistry analytes. In addition, the laboratories completed a questionnaire about how hemolyzed samples are handled and reported. Results Automated detection of hemolysis in all routine patient samples was used by 63% of laboratories, and 88% had written procedures on how to handle hemolyzed samples. The different instrument platforms measured comparable mean Hb concentrations in the four samples. For most analytes, hemolysis caused a homogenous degree of interference regardless of the instrument platform used, except for alkaline phosphatase (ALP), bilirubin (total) and creatine kinase (CK). The recommended cut-off points for rejection of a result varied substantially between the manufacturers. The laboratories differed in how they reported test results, even when they used the same type of instrument. Conclusions Most of the analytes were homogeneously affected by hemolysis, regardless of the instrument used. There is large variation, however, between the laboratories on how they report test results from hemolyzed samples, even when they use the same type of instrument.
Keywords: analytical interference; hemoglobin; hemolysis; laboratory errors; preanalytical phase.