Low Power Contactless Voltage Sensor for Low Voltage Power Systems

Sensors (Basel). 2019 Aug 11;19(16):3513. doi: 10.3390/s19163513.

Abstract

Contactless measurements represent the desirable solution in many contexts, where minimal cabling is required or, in general, cabling is not possible. This paper presents a new contactless voltage sensor for low voltage power systems. It is based on a contactless capacitive probe, which surrounds the power cable. It has two concentric electrodes insulated by a shield. A low power analog conditioning circuit evaluates the power line voltage by measuring the current in one of the capacitances of the probe. All the single stages of the circuit have been designed by using low-power rail-to-rail operational amplifiers, supplied at 3.3 V, in order to minimize the power absorption. The sensor has been characterized in various conditions, with sine waves and distorted signals, varying the frequency and the harmonic distortion. The influence of the current, flowing into the power cable, on the voltage measurement has been evaluated too. It shows a good accuracy (lower than 0.3%) from 100 V to 300 V, with a power consumption less than 5 mW.

Keywords: contactless; low power; non-sinusoidal conditions; power system measurements; sensor; voltage measurement.