In arid Mediterranean countries, such as Tunisia, wastewater often has high salinity, being an obstacle to the elimination of microcontaminants for the reuse of water in agriculture. In this paper, the photo-Fenton process in raceway pond reactors (RPRs) has been successfully applied to a simulated secondary effluent from a Tunisian urban wastewater treatment plant (WWTP), with high chloride load. A mixture of three contaminants of emerging concern (CECs) was used as model pollutants at 50 μg/L each (one antibiotic, sulfamethoxazole and two pesticides, pyrimicarb and imidacloprid). All the assays were conducted at neutral pH with 0.1 mM Fe(III):EDDS at 1:1 molar ratio. The effect of hydrogen peroxide initial concentration (20, 30, and 90 mg/L) on microcontaminant removal was studied. Different liquid depths (5 and 15 cm) were selected to assess the relationship between the microcontaminant removal and the volumetric rate of photon absorption (VRPA). Although the reaction rate was initially photo-limited, after a short reaction time of 15 min, the final yield (≈ 80% of CEC removal) was limited by the photo-degradation of the Fe(III):EDDS complex and excess H2O2 was found at all concentrations used. Therefore, treatment times below 15 min should be used. The treatment capacity was three times higher when the liquid depth was increased from 5 to 15 cm. For the first time, these results show that the operation of a 15 cm-deep RPR in continuous flow mode would be suitable for large-scale implementation of the solar photo-Fenton process.
Keywords: Imidacloprid; Pyrimicarb; Solar radiation; Sulfamethoxazole; VRPA; Wastewater treatment.