Catalyst-free activation of persulfate by visible light for water disinfection: Efficiency and mechanisms

Wanjun Wang; Hanna Wang; Guiying Li; Taicheng An; Huijun Zhao; Po Keung Wong

doi:10.1016/j.watres.2019.03.071

Catalyst-free activation of persulfate by visible light for water disinfection: Efficiency and mechanisms

Water Res. 2019 Jun 15:157:106-118. doi: 10.1016/j.watres.2019.03.071. Epub 2019 Mar 28.

Authors

Wanjun Wang¹, Hanna Wang¹, Guiying Li¹, Taicheng An², Huijun Zhao³, Po Keung Wong⁴

Affiliations

¹ Guangzhou Key Laboratory of Environmental Catalysis and Pollution Control, Guangdong Key Laboratory of Environmental Catalysis and Health Risk Control, School of Environmental Science and Engineering, Institute of Environmental Health and Pollution Control, Guangdong University of Technology, Guangzhou, China.
² Guangzhou Key Laboratory of Environmental Catalysis and Pollution Control, Guangdong Key Laboratory of Environmental Catalysis and Health Risk Control, School of Environmental Science and Engineering, Institute of Environmental Health and Pollution Control, Guangdong University of Technology, Guangzhou, China. Electronic address: antc99@gdut.edu.cn.
³ Centre for Clean Environment and Energy, and Griffith School of Environment, Gold Coast Campus, Griffith University, Queensland, 4222, Australia.
⁴ School of Life Sciences, The Chinese University of Hong Kong, Shatin, NT, Hong Kong, China. Electronic address: pkwong@cuhk.edu.hk.

PMID: 30953846
DOI: 10.1016/j.watres.2019.03.071

Abstract

The development of cost-effective water disinfection methods is highly desired to address the problems caused by outbreak of harmful microorganisms. Sulfate radical (•SO₄^-)-based advanced oxidation technology has attracted increasing attention. However, various catalysts or UV irradiation are usually used to activate persulfate (PS), which is high-cost and the recovery of nano-sized catalysts is also challenging. This work demonstrates a new method of catalyst-free activation of persulfate by visible light (VL) for bacterial inactivation. The 6-log of E. coli cells can be inactivated within 40 min and 7-log of E. coli cells could be inactivated within 120 min by the VL/PS system. The major responsive wavelength is 420 nm, and no heat activation of PS is found during VL irradiation. A synergistic effect with synergy factor of 51.2% is found when combining the VL irradiation with heating at 50 °C. The acidic pH is benefit for the VL/PS-triggered bacterial inactivation, while bicarbonate inhibits the E. coli inactivation at the range of 0.1-20 mg/L. Mechanism study indicates the main reactive species are •SO₄^-, •O₂^- and •OH, in which •SO₄^- plays the most important role. The bacterial inactivation process shows to begin from outer membrane to intracellular components. Subsequently, the antioxidant enzyme (i.e. SOD, CAT) is induced, followed by damaging to the genomic DNA leading to fatal death of the cells. In addition, the VL/PS system is also applicable for the inactivation of other pathogenic bacteria, including Staphylococcus aureus and Pseudomonas aeruginosa, showing universality for water disinfection applications. This work not only provides a new cost-effective disinfection method without a catalyst, but also sheds light on understanding the bacterial inactivation mechanism by •SO₄^--based AOPs.

Keywords: Catalyst-free; Persulfate; Sulfate radical; Visible light; Water disinfection.

MeSH terms

Catalysis
Disinfection
Escherichia coli
Water Purification*
Water*

Substances

Water