Objectives:: This study tested whether delayed photoactivation could reduce shrinkage stresses in dual-cure composites and how it affected the depth-of-cure and mechanical properties.
Methods and materials:: Two dual-cure composites (ACTIVA and Bulk EZ) were subjected to two polymerization protocols: photoactivation at 45 seconds (immediate) or 165 seconds (2 minutes delayed) after extrusion. Typodont premolars with standardized preparations were restored with the composites, and cuspal flexure caused by polymerization shrinkage was determined with three-dimensional scanning of the external tooth surfaces before restoration (baseline) and at 10 minutes and one hour after photoactivation. Bond integrity (intact interface) was verified with dye penetration. Depth-of-cure was determined by measuring Vickers hardness through the depth at 1-mm increments. Elastic modulus and maximum stress were determined by four-point bending tests (n=10). Results were analyzed with two- or three-way analysis of variance and pairwise comparisons (Bonferroni; α=0.05).
Results:: Delayed photoactivation significantly reduced cuspal flexure for both composites at 10 minutes and one hour ( p≤0.003). Interface was >99% intact in every group. Depth-of-cure, elastic modulus, and flexural strength were not significantly different between the immediate and delayed photoactivation ( p>0.05). The hardness of ACTIVA reduced significantly with depth ( p<0.001), whereas the hardness of Bulk EZ was constant throughout the depth ( p=0.942).
Conclusions:: Delayed photoactivation of dual-cure restorative composites can reduce shrinkage stresses without negatively affecting the degree-of-cure or mechanical properties (elastic modulus and flexural strength).