The aim of this study was to evaluate the factors affecting intra-oral scanner accuracy by analyzing variation in measurements of a dental model according to scanning distance. A dental cast, including a prepared left mandibular first molar, was used. Rectangular frames measuring 20 × 30 mm with heights of 2.5, 5.0, and 7.5 mm were made. The model was scanned 10 times with a reference scanner to obtain the true value. Scanning was performed 10 times at four distances of 0, 2.5, 5.0, and 7.5 mm with the frame of each height using the following intra-oral scanners: TRIOS; CS 3500; and PlanScan. In the linear distance measurement method (2D), measurements were taken at five parameters using the Rapidform software. In the best-fit alignment method (3D), using the Geomagic Control X, the root mean square values of the two scan images were calculated. In the 2D comparison, the different from the reference value was the smallest at 2.5 and 5.0 mm. In the 3D comparison, 2.5 and 5.0 mm were the most accurate, and 0 mm was the least accurate among the four distances. To the best of our knowledge, this study was the first to evaluate the accuracy of scanning distances, and found a difference between the accuracy of the scanning distance and the accuracy of the scanner. Moreover, the results of this study indicated that the scanning distance was a variable affecting accuracy. Clin. Anat. 32:430-438, 2019. © 2019 Wiley Periodicals, Inc.
Keywords: anatomic; computer aided design; computer-assisted; dental impression technique; image processing; imaging; models; three-dimensional.
© 2019 Wiley Periodicals, Inc.