Enhanced Numerical Method for the Design of 3-D-Printed Holographic Acoustic Lenses for Aberration Correction of Single-Element Transcranial Focused Ultrasound

Abstract

The correction of transcranial focused ultrasound aberrations is a relevant issue for enhancing various non-invasive medical treatments. The emission through multi-element phased arrays has been the most widely accepted method to improve focusing in recent years; however, the number and size of transducers represent a bottleneck that limits the focusing accuracy of the technique. To overcome this limitation, a new disruptive technology, based on 3-D-printed acoustic lenses, has recently been proposed. As the submillimeter precision of the latest generation of 3-D printers has been proven to overcome the spatial limitations of phased arrays, a new challenge is to improve the accuracy of the numerical simulations required to design this type of ultrasound lens. In the study described here, we evaluated two improvements in the numerical model applied in previous works for the design of 3-D-printed lenses: (i) allowing the propagation of shear waves in the skull by means of its simulation as an isotropic solid and (ii) introduction of absorption into the set of equations that describes the dynamics of the wave in both fluid and solid media. The results obtained in the numerical simulations are evidence that the inclusion of both s-waves and absorption significantly improves focusing.

Keywords: 3-D-printed lenses; Focused ultrasound; Single-element transducer; Transcranial therapy; Transcranial ultrasound.