Influence of preparation design and spacing parameters on the risk of chipping of crowns made with Cerec Bluecam before cementation

Abstract

Purpose: To evaluate the influence of the preparation design and spacing parameters on the risk of chipping of crowns made by CEREC Bluecam before cementation.

Methods: A knife-edge preparation and a chamfer preparation were made on upper premolars. The teeth were scanned and two Co-Cr alloy replicas were made. Fifteen full crowns were manufactured for four groups using CEREC. The groups differed in type of preparation (knife-edge (KE) or chamfer (CHA)) and spacing parameters: spacer (0 or 150μm), marginal adhesive gap (10 or 50 or 150μm) and margin thickness (0 or 300μm). The four groups were: CHA 150 (spacer)- 50 (marginal adhesive gap)- 0 (margin thickness), KE 150-50-0, KE 150-50-300 and KE 150-150-300. The crowns were loaded before cementation by using an Instron machine to simulate the masticatory load applied during a trial. Differences in means were compared using two-way ANOVA and a post-hoc test (Tukey Test). The level of significance was set at P=0.05.

Results: The fracture values, ordered from least to most resistant, were: KE 150-50-300 group, CHA 150-50-0 group, KE 150-50-0 group and KE 150-150-300 group. Two-way ANOVA revealed statistically significant differences between pairs of means (p<0.05). Tukey's test showed that restorations of the KE 150-150-300 group can withstand a load significantly higher than that of other groups (p<0.01). In this group, the failures were mostly minor chippings, while the other groups had mostly major chippings and fractures.

Conclusions: Marginal adhesive gap can affect the trial of a full crown.

Keywords: CAD-CAM; Knife-edge preparation; Spacing parameters; Try-in phase.