Polymer flow during wire coating dragged from a bath of viscoelastic incompreesible and laminar fluid inside pressure type die is carried out numerically. In wire coating the flow depends on the velcocity of the wire, geometry of the die and viscosity of the fluid. The governing equations expressing the heat transfer and flow solved numerically by Runge-Kutta fourth order method with shooting technique. Reynolds model and Vogel's models are encountered for temperature dependent viscosity. The umerical solutions are obtained for velocity field and temperature distribution. It is seen that the non-Newtonian parameter of the fluid accelerates the velcoty profile in the absence of porous and magnetic parameters. For large value of magnetic parameter the reverse effect is observed. It is observed that the temperature profiles decreases with increasing psedoplastic parameter in the presence and absence of porous matrix as well as magnetic parameter. The Brinkman number contributes to increase the temperature for both Reynolds and Vogel'smmodels. With the increasing of pressure gradient parameter of both Reynolds and Vogel's models, the velocity and temperature profile increases significantly in the presence of non-Newtonian parameter. The solutions are computed for different physical parameters. Furthermore, the present result is also compared with published results as a particular case.