Cellulose paper is an attractive substrate for paper electronics because of its advantages of flexibility, biodegradability, easy incorporation into composites, low cost and eco-friendliness. However, the micrometre-sized pores of cellulose paper make robust/conductive films difficult to deposit onto its surface from metal-nanoparticle-based inks. We developed a Cu-based composite ink to deposit conductive Cu films onto cellulose paper via low-temperature sintering in air. The Cu-based inks consisted of a metallo-organic decomposition ink and formic-acid-treated Cu flakes. The composite ink was heated in air at 100°C for only 15 s to give a conductive Cu film (7 × 10-5 Ω cm) on the cellulose paper. Filtration of the Cu-based composite ink accumulated Cu flakes on the paper, which enabled formation of a sintered Cu film with few defects. A strategy was developed to enhance the bending stability of the sintered Cu films on paper substrates using polyvinylpyrrolidone-modified Cu flakes and amine-modified paper. The resistance of the Cu films increased only 1.3-fold and 1.1-fold after 1000 bending cycles at bending radii of 5 mm and 15 mm, respectively. The results of this study provide an approach to increasing the bending stability of Cu films on cellulose paper.
Keywords: air-atmosphere sintering; copper ink; flexible devices; paper electronics.