This paper presents a 612⁻1152 MHz Injection-Locked Frequency Multiplier (ILFM). The proposed ILFM is used to send an input signal to a receiver in only the I/Q mismatch calibration mode. Adopting a Phase-Locked Loop (PLL) to calibrate the receiver places a burden on this system because of the additional area and power consumption that is required. Instead of the PLL, to satisfy high-frequency, low-jitter and low-area requirements, a Ring Oscillator is adopted in the system. The free-running frequency of the ILFM is automatically and digitally calibrated to reflect the frequency of the injected signal from the harmonics of the reference clock. To control the frequency of the ILFM, the load current is digitally tuned with a 6-bit digital control signal. The proposed ILFM locks to the target frequency using a digitally controlled Frequency Locked Loop (FLL). This chip is fabricated using 1-poly 6-metal 0.18 µm CMOS and has achieved the wide tuning range of 612⁻1152 MHz. The power consumption is 0.95 mW from a supply voltage of 1.8 V. The measured phase noise of the ILFM is -108 dBc/Hz at a 1 MHz offset.
Keywords: frequency locked loop (FLL); injection locked frequency multiplier; phase noise.