Cu(In,Ga)Se2 Solar Cells with Amorphous In2O3-Based Front Contact Layers

Takashi Koida; Yuko Ueno; Jiro Nishinaga; Hirohumi Higuchi; Hideki Takahashi; Masayuki Iioka; Hajime Shibata; Shigeru Niki

doi:10.1021/acsami.7b07092

Cu(In,Ga)Se₂ Solar Cells with Amorphous In₂O₃-Based Front Contact Layers

ACS Appl Mater Interfaces. 2017 Sep 6;9(35):29677-29686. doi: 10.1021/acsami.7b07092. Epub 2017 Aug 22.

Authors

Takashi Koida¹, Yuko Ueno¹, Jiro Nishinaga¹, Hirohumi Higuchi¹, Hideki Takahashi¹, Masayuki Iioka¹, Hajime Shibata¹, Shigeru Niki¹

Affiliation

¹ Research Center for Photovoltaics, National Institute of Advanced Industrial Science and Technology , 1-1-1 Umezono, Tsukuba 305-8568, Japan.

PMID: 28828852
DOI: 10.1021/acsami.7b07092

Abstract

Amorphous (a-) In₂O₃-based front contact layers composed of transparent conducting oxide (TCO) and transparent oxide semiconductor (TOS) layers were proved to be effective in enhancing the short-circuit current density (J_sc) of Cu(In,Ga)Se₂ (CIGS) solar cells with a glass/Mo/CIGS/CdS/TOS/TCO structure, while maintaining high fill factor (FF) and open-circuit voltage (V_oc). An n-type a-In-Ga-Zn-O layer was introduced between the CdS and TCO layers. Unlike unintentionally doped ZnO broadly used as TOS layers in CIGS solar cells, the grain-boundary(GB)-free amorphous structure of the a-In-Ga-Zn-O layers allowed high electron mobility with superior control over the carrier density (N). High FF and V_oc values were achieved in solar cells containing a-In-Ga-Zn-O layers with N values broadly ranging from 2 × 10¹⁵ to 3 × 10¹⁸ cm^-3. The decrease in FF and V_oc produced by the electronic inhomogeneity of solar cells was mitigated by controlling the series resistance within the TOS layer of CIGS solar cells. In addition, a-In₂O₃:H and a-In-Zn-O layers exhibited higher electron mobilities than the ZnO:Al layers conventionally used as TCO layers in CIGS solar cells. The In₂O₃-based layers exhibited lower free carrier absorption while maintaining similar sheet resistance than ZnO:Al. The TCO and TOS materials and their combinations did not significantly change the V_oc of the CIGS solar cells and the mini-modules.

Keywords: In2O3; a-IGZO; amorphous; chalcopyrite compound; oxide semiconductor; photovoltaic cells; photovoltaic modules; transparent conducting oxide.