Super-hydrophobic coatings based on non-solvent induced phase separation during electro-spraying

Jiefeng Gao; Xuewu Huang; Ling Wang; Nan Zheng; Wan Li; Huaiguo Xue; Robert K Y Li; Yiu-Wing Mai

doi:10.1016/j.jcis.2017.07.089

Super-hydrophobic coatings based on non-solvent induced phase separation during electro-spraying

J Colloid Interface Sci. 2017 Nov 15:506:603-612. doi: 10.1016/j.jcis.2017.07.089. Epub 2017 Jul 25.

Authors

Jiefeng Gao¹, Xuewu Huang², Ling Wang², Nan Zheng³, Wan Li⁴, Huaiguo Xue², Robert K Y Li⁴, Yiu-Wing Mai⁵

Affiliations

¹ School of Chemistry and Chemical Engineering, Yangzhou University, Yangzhou, Jiangsu 225002, China; Department of Physics and Materials Science, City University of Hong Kong, Tat Chee Avenue, Kowloon, Hong Kong; Centre for Advanced Materials Technology (CAMT), School of Aerospace, Mechanical and Mechatronic Engineering J07, The University of Sydney, Sydney, NSW 2006, Australia. Electronic address: jfgao@yzu.edu.cn.
² School of Chemistry and Chemical Engineering, Yangzhou University, Yangzhou, Jiangsu 225002, China.
³ Centre for Advanced Materials Technology (CAMT), School of Aerospace, Mechanical and Mechatronic Engineering J07, The University of Sydney, Sydney, NSW 2006, Australia.
⁴ Department of Physics and Materials Science, City University of Hong Kong, Tat Chee Avenue, Kowloon, Hong Kong.
⁵ Centre for Advanced Materials Technology (CAMT), School of Aerospace, Mechanical and Mechatronic Engineering J07, The University of Sydney, Sydney, NSW 2006, Australia. Electronic address: yiu-wing.mai@sydney.edu.au.

PMID: 28759860
DOI: 10.1016/j.jcis.2017.07.089

Abstract

Hypothesis: The polymer solution concentration determines whether electrospinning or electro-spraying occurs, while the addition of the non-solvent into the polymer solution strongly influences the surface morphology of the obtained products. Both smooth and porous surfaces of the electro-sprayed microspheres can be harvested by choosing different non-solvent and its amount as well as incorporating polymeric additives.

Experiments: The influences of the solution concentration, weight ratio between the non-solvent and the copolymer, and the polymeric additives on the surface morphology and the wettability of the electro-sprayed products were systematically studied.

Findings: Surface pores and/or asperities on the microsphere surface were mainly caused by the non-solvent induced phase separation (NIPS) and subsequent evaporation of the non-solvent during electro-spraying. With increasing polymer solution concentration, the microsphere was gradually changed to the bead-on-string geometry and finally to a nanofiber form, leading to a sustained decrease of the contact angle (CA). It was found that the substrate coatings derived from the microspheres possessing hierarchical surface pores or dense asperities had high surface roughness and super-hydrophobicity with CAs larger than 150° while sliding angles smaller than 10°; but coatings composed of microspheres with smooth surfaces gave relatively low CAs.

Keywords: Electro-spraying; Microspheres; Porous; Super-hydrophobic.