Selective demineralisation of dentine extrafibrillar minerals-A potential method to eliminate water-wet bonding in the etch-and-rinse technique

J Dent. 2016 Sep:52:55-62. doi: 10.1016/j.jdent.2016.07.008. Epub 2016 Jul 18.

Abstract

Objective: The present study tested the central hypothesis that selective demineralisation of dentine extrafibrillar minerals by lowering the phosphoric acid concentration improves the quality of the resin-dentine interface.

Methods: Dentine surfaces were etched with different concentrations of phosphoric acid (1, 5, 10, 20, 30 or 40wt%). Scanning electron microscopy was used to observe the micromorphology of the etched dentine surfaces. Energy dispersive X-ray analysis was performed to determine the residual Ca-content of the demineralised dentine matrix. Atomic force microscopy-based nanoindentation was used to analyse the nanomechanical properties of the treated dentine surfaces. The influence of H3PO4 concentration on resin-dentine bond strength was evaluated by microtensile bond strength testing. One-way ANOVA was used to compare the residual Ca-content ratio, reduced elastic modulus (Er) of the treated dentine surfaces and microtensile bond strength among groups.

Results: Collagen fibrils appeared to be wider in diameter after etching with 5% and 10% H3PO4. The partially-demineralized collagen scaffold retained part of its rigidity to maintain an uncollapsed three-dimensional structure. Etching with 1% H3PO4 resulted in the highest residual Ca-content ratio and Er of demineralised dentine matrix, followed by 5% H3PO4. Those values were all significantly higher than values derived from the other groups. Etching with 30% H3PO4 resulted in the lowest Ca-content ratio and Er. Using 5% H3PO4 as etchant resulted in the highest resin-dentine bond strength.

Conclusions: Selective demineralisation of the dentine matrix may be achieved by lowering the H3PO4 concentration to 5wt%, to achieve better bonding performance.

Clinical relevance: By retaining intrafibrillar minerals, more through air-drying of the partially demineralised collagen matrix may be accomplished without the need to worry about collapsing a mineral-free collagen matrix during air-drying. This may result in the elimination of water-wet bonding during the application of etch-and-rinse adhesives.

Keywords: Collagen matrix; Etch-and-rinse; Interfibrillar space; Intrafibrillar mineral; Selective demineralisation.

MeSH terms

  • Bone Density
  • Dental Bonding
  • Dentin*
  • Dentin-Bonding Agents
  • Microscopy, Electron, Scanning
  • Resin Cements
  • Tensile Strength
  • Water

Substances

  • Dentin-Bonding Agents
  • Resin Cements
  • Water