Pectin was extracted from tomato waste using two different extraction methods to assess its potential utilization as an alternative source of commercial pectin production. Tomato waste was treated with ammonium oxalate/oxalic acid by conventional extraction (CE), under reflux and ultrasound assisted extraction (UAE) at 37 kHz and temperatures of 60 °C and 80 °C. The pectin obtained from these methods was analysed and compared in terms of yield, chemical properties and structure. Among examined methods, CE at 60 °C resulted with the highest yield, but UAE during 15 min of sonication produced the pectin of better quality (anhydrouronic acid, methoxy and calcium pectate contents and degree of esterification). NMR and FTIR spectroscopy of isolated pectins revealed predominantly esterified structure, irrespective of extraction conditions. The comparison of the pectin yields obtained after extraction at 80 °C, indicate that similar values were found at times of 24h and 15 min for CE and UAE, respectively. According to obtained results it can be concluded that main advantage of UAE is considerable shortening of extraction procedure with strong emphasis on environmental friendly processing approach. Therefore, these results suggested that UAE could be used as an efficient technique for the extraction of pectin from tomato waste and by-products.
Keywords: Conventional extraction; NMR and IR spectroscopy; Pectin; Sonication; Tomato waste.
Copyright © 2015 Elsevier Ltd. All rights reserved.