Objective: To explore the quantitative relationship between the dust mass concentration and fiber number concentration of refractory ceramic fibres.
Methods: A typical refractory ceramic fiber plant was selected as the study site. Fifty-three paired samples of total dust mass concentration and fiber number concentration were collected using the long-time fixed site mode. The total dust mass concentration was measured according to the GBZ/T 192.1-2007 (Measurement of dust in the air of workplace, part 1: Total dust concentration). Membrane filter method/phase-contrast optical microscopy was used to determine the fiber number concentration. Univariate analysis was used to describe the distribution of the two concentrations and their ratio. Spearman rank correlation, as well as linear regression, logarithmic curve, polynomial, power function, and exponential curve model, were used to explore the relationship between the two concentrations. Results The range of the total dust mass concentration (x) was 0.45-13.82 mg/m3. The range of the fiber number concentration (y) was 0.01-1.04 f/ml. The range of the ratio (x/y) was 4-158. All of the three parameters did not follow normal distribution (P<0.000 1). The two concentrations showed a positive correlation (r,=0.705 22, P< 0.000 1). All the coefficients of determination (R2) of linear regression, logarithmic curve, polynomial, power function, and exponential curve model were relatively low. The trinomial curve model had the highest R2 (0.6848) and the fitted equation was y=-0.001, 1x+0.010 4x2+0.101 4x-0.055 1.
Conclusion: There is a positive correlation between the total dust mass concentration and fiber number concentration of refractory ceramic fibers. However, there is no fixed regression relationship between the two concentrations, and neither is a definite coefficient which can be used to convert each other. The two concentrations cannot be replaced by each other.