In vitro biomechanical evaluation of internal fixation techniques on the canine lumbosacral junction

Peter Early; Peter Mente; Stacy Dillard; Simon Roe

doi:10.7717/peerj.1094

In vitro biomechanical evaluation of internal fixation techniques on the canine lumbosacral junction

PeerJ. 2015 Aug 20:3:e1094. doi: 10.7717/peerj.1094. eCollection 2015.

Authors

Peter Early¹, Peter Mente², Stacy Dillard³, Simon Roe¹

Affiliations

¹ College of Veterinary Medicine, North Carolina State University , Raleigh, NC , USA.
² Joint Department of Biomedical Engineering at the University of North Carolina Chapel Hill, North Carolina State University , Raleigh, NC , USA.
³ Veterinary Neurology Center , Tustin, CA , USA.

Abstract

Few biomechanical studies have evaluated the effect of internal stabilization techniques after decompressive surgery on the stability of the canine lumbosacral junction. The purpose of this canine cadaver study is to evaluate the stability of the canine lumbosacral (LS) spine in flexion and extension following laminectomy and discectomy and then stabilization with each of the three techniques: pins and polymethylmethacrylate (P/PMMA), two dorsal locking plates (SOP) or bilateral transarticular facet screws (FACET).Using a cantilever biomechanical system, bending moments were applied to the LS and range of motion (ROM) was recorded via a rotational potentiometer. With 3 Nm, the ROM (n = 4 in each group) for P/PMMA, SOP and FACET were 1.92 ± 0.96°, 2.56 ± 0.55°and 3.18 ± 1.14°, respectively. With moments up to 35 Nm, the P/PMMA specimens appeared stable. Sacroiliac motion in the SOP and FACET groups invalidated further comparisons. Each of the stabilization techniques (P/PMMA, SOP, and FACET) significantly decreased the range of motion in flexion and extension for low bending moments.

Keywords: Biomechanics; Dog; Lumbosacral; PMMA; SOP; Transarticular facet.

Grants and funding

The Department of Clinical Sciences at NCSU supported part of the funding for this system. The funders had no role in study design, data collection and analysis, decision to publish, or preparation of the manuscript.