Application of an electrochemical treatment for EDDS soil washing solution regeneration and reuse in a multi-step soil washing process: Case of a Cu contaminated soil

Abstract

Soil washing is an extensively used process for remediation of heavy metals contaminated soils. However the amount of fresh washing solution to be used represents a significant economical drawback of this process. This paper investigates the application of an electrochemical process (Fe/Fe electrodes couple) for the regeneration of a spent EDDS solution, containing Cu and major competitor cations (Ca, Fe, Mg, and Mn). The effect of current density, pH and conductivity of the washing solution on the recovery process performances was investigated. Current density showed the highest influence on Cu, Mg and Mn removal yields. Maximum removal yields reached 99% for Cu, 77% for Mn and 49% for Mg. No influence of the investigated parameters on Ca removal was observed, while an increase of Fe concentration due to anode dissolution occurred. Characterization of sludge produced from the 2 h electrochemical test (5 mA cm(-2), pH = 8, 8 mS cm(-1)) displayed concentrations of 2.8 g kg(-1) for Ca, 0.4 g kg(-1) for Cu, 535.6 g kg(-1) for Fe, 2.6 g kg(-1) for Mg. TCLP tests at pH 2.88 and 4.93 showed a low leaching percentage (Ca, 10-21%; Cu, 6-12%; Fe, 0.22% Mg, 27-36%). Multi-washing tests were carried out to assess the decrease of the chelating ability of the regenerated washing solution and the Cu extraction efficiency.

Keywords: EDDS recovery; Electrochemical treatment; HMs removal; Multistep washing; Soil washing.