Polymeric microparticles with complex shapes have attracted substantial attention in many application areas because particle shape is a critical parameter to impart programmable functionalities. The formation of specific three-dimensional (3D) microstructures in a simple, scalable, and controllable manner is difficult. Here, we report the controlled fabrication of microparticles with complex 3D shapes based on the simple tuning of mold swelling and capillarity. Specifically, a photocurable solution loaded in micromolds is spatially deformed into complex shapes depending on the degree of molding swelling and capillarity, thereby producing polymeric microparticles with controlled 3D shapes upon photopolymerization. The results show that highly uniform microparticles with controlled two-dimensional (2D) and 3D shapes were fabricated from identical 2D micromolds via the simple tuning of the wetting fluids. This technique can be extended to produce highly complex microarchitectures with controlled 3D geometric domains via 2D mold designs. Finally, multicompartment microparticles with independently controlled 3D shapes for each compartment are produced by a simple combination of fabrication sequences. We envision that this strategy of producing 3D microarchitectures from easily designed simple micromolds could provide a path to new materials and new properties.
Keywords: 3D geometries; capillarity; deformation; microarchitecture; micromolding.