Thermoluminescence characteristics of Ge-doped optical fibers with different dimensions for radiation dosimetry

Mahfuza Begum; A K M Mizanur Rahman; H A Abdul-Rashid; Z Yusoff; Mahbuba Begum; K A Mat-Sharif; Y M Amin; D A Bradley

doi:10.1016/j.apradiso.2014.10.025

Thermoluminescence characteristics of Ge-doped optical fibers with different dimensions for radiation dosimetry

Appl Radiat Isot. 2015 Jun:100:79-83. doi: 10.1016/j.apradiso.2014.10.025. Epub 2014 Nov 7.

Authors

Mahfuza Begum¹, A K M Mizanur Rahman², H A Abdul-Rashid³, Z Yusoff³, Mahbuba Begum⁴, K A Mat-Sharif⁵, Y M Amin⁶, D A Bradley⁷

Affiliations

¹ Faculty of Engineering, Multimedia University, 63100 Cyberjaya, Selangor Darul Ehsan, Malaysia; Bangladesh Atomic Energy Commission, Bangladesh. Electronic address: go2munmun@yahoo.com.
² Faculty of Engineering, Multimedia University, 63100 Cyberjaya, Selangor Darul Ehsan, Malaysia; Bangladesh Atomic Energy Commission, Bangladesh.
³ Faculty of Engineering, Multimedia University, 63100 Cyberjaya, Selangor Darul Ehsan, Malaysia.
⁴ Bangladesh Atomic Energy Commission, Bangladesh.
⁵ Telekom Research and Development, Lingkaran Teknokrat Timur, 63000 Cyberjaya, Selangor Darul Ehsan, Malaysia.
⁶ Department of Physics, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia.
⁷ Department of Physics, University of Surrey, Guildford GU2 7XH, UK.

PMID: 25468288
DOI: 10.1016/j.apradiso.2014.10.025

Abstract

Important thermoluminescence (TL) properties of five (5) different core sizes Ge-doped optical fibers have been studied to develop new TL material with better response. These are drawn from same preform applying different speed and tension during drawing phase to produce Ge-doped optical fibers with five (5) different core sizes. The results of the investigations are also compared with most commonly used standard TLD-100 chips (LiF:Mg,Ti) and commercial multimode Ge-doped optical fiber (Yangtze Optical Fiber, China). Scanning Electron Microscope (SEM) and EDX analysis of the fibers are also performed to map Ge distribution across the deposited region. Standard Gamma radiation source in Secondary Standard Dosimetry Lab (SSDL) was used for irradiation covering dose range from 1Gy to 10Gy. The essential dosimetric parameters that have been studied are TL linearity, reproducibility and fading. Prior to irradiation all samples ∼0.5cm length are annealed at temperature of 400°C for 1h period to standardize their sensitivities and background. Standard TLD-100 chips are also annealed for 1h at 400°C and subsequently 2h at 100°C to yield the highest sensitivity. TL responses of these fibers show linearity over a wide gamma radiation dose that is an important property for radiation dosimetry. Among all fibers used in this study, 100μm core diameter fiber provides highest response that is 2.6 times than that of smallest core (20μm core) optical fiber. These fiber-samples demonstrate better response than commercial multi-mode optical fiber and also provide low degree of fading about 20% over a period of fifteen days for gamma radiation. Effective atomic number (Zeff) is found in the range (13.25-13.69) which is higher than soft tissue (7.5) however within the range of human-bone (11.6-13.8). All the fibers can also be re-used several times as a detector after annealing. TL properties of the Ge-doped optical fibers indicate promising applications in ionizing radiation dosimetry.

Keywords: Effective atomic number; Ge-doped optical fiber; Radiation dosimetry; SEM–EDX analysis.