A wide range of poly(hydroxyalkanoate)s (PHAs), a class of biodegradable polyesters produced by various bacteria grown under unbalanced conditions, have been proposed for the fabrication of tissue-engineering scaffolds. In this study, the manufacture of poly[(R)-3-hydroxybutyrate-co-(R)-3-hydroxyhexanoate] (or PHBHHx) scaffolds, by means of an additive manufacturing technique based on a computer-controlled wet-spinning system, was investigated. By optimizing the processing parameters, three-dimensional scaffolds with different internal architectures were fabricated, based on a layer-by-layer approach. The resulting scaffolds were characterized by scanning electron microscopy, which showed good control over the fibre alignment and a fully interconnected porous network, with porosity in the range 79-88%, fibre diameter 47-76 µm and pore size 123-789 µm. Moreover, the resulting fibres presented an internal porosity connected to the external fibre surface as a consequence of the phase-inversion process governing the solidification of the polymer solution. Scaffold compressive modulus and yield stress and strain could be varied in a certain range by changing the architectural parameters. Cell-culture experiments employing the MC3T3-E1 murine pre-osteoblast cell line showed good cell proliferation after 21 days of culture. The PHBHHx scaffolds demonstrated promising results in terms of cell differentiation towards an osteoblast phenotype. Copyright © 2014 John Wiley & Sons, Ltd.
Keywords: additive manufacturing; poly(hydroxyalkanoate)s; poly[(R)-3-hydroxybutyrate-co-(R)-3-hydroxyhexanoate]; rapid prototyping; scaffold; tissue engineering; wet-spinning.
Copyright © 2014 John Wiley & Sons, Ltd.