A CMOS power-efficient low-noise current-mode front-end amplifier for neural signal recording

IEEE Trans Biomed Circuits Syst. 2013 Apr;7(2):107-14. doi: 10.1109/TBCAS.2013.2256422.

Abstract

In this paper, a new current-mode front-end amplifier (CMFEA) for neural signal recording systems is proposed. In the proposed CMFEA, a current-mode preamplifier with an active feedback loop operated at very low frequency is designed as the first gain stage to bypass any dc offset current generated by the electrode-tissue interface and to achieve a low high-pass cutoff frequency below 0.5 Hz. No reset signal or ultra-large pseudo resistor is required. The current-mode preamplifier has low dc operation current to enhance low-noise performance and decrease power consumption. A programmable current gain stage is adopted to provide adjustable gain for adaptive signal scaling. A following current-mode filter is designed to adjust the low-pass cutoff frequency for different neural signals. The proposed CMFEA is designed and fabricated in 0.18-μm CMOS technology and the area of the core circuit is 0.076 mm(2). The measured high-pass cutoff frequency is as low as 0.3 Hz and the low-pass cutoff frequency is adjustable from 1 kHz to 10 kHz. The measured maximum current gain is 55.9 dB. The measured input-referred current noise density is 153 fA /√Hz , and the power consumption is 13 μW at 1-V power supply. The fabricated CMFEA has been successfully applied to the animal test for recording the seizure ECoG of Long-Evan rats.

Publication types

  • Research Support, Non-U.S. Gov't

MeSH terms

  • Amplifiers, Electronic*
  • Animals
  • Biomedical Engineering
  • Disease Models, Animal
  • Electric Power Supplies
  • Electronics, Medical / instrumentation
  • Epilepsy / physiopathology*
  • Equipment Design
  • Feedback
  • Models, Neurological
  • Neural Networks, Computer
  • Neurons / physiology*
  • Rats
  • Rats, Long-Evans
  • Signal Processing, Computer-Assisted*