Geometrically well-defined Cu6Sn5 thin films were used as a model system to estimate the diffusion depth and diffusion pathway requirements of Na ions in alloy anodes. Cu6Sn5 anodes have an initial reversible capacity towards Li of 545 mA h g(-1) (Li3.96Sn or 19.8 Li/Cu6Sn5), close to the theoretical 586 mA h g(-1) (Li4.26Sn), and a very low initial irreversible capacity of 1.6 Li/Cu6Sn5 (Li0.32Sn). In contrast, the reaction with Na is limited with a reversible capacity of 160 mA h g(-1) compared to the expected 516 mA h g(-1) (Na3.75Sn). X-ray diffraction and (119)Sn-Mössbauer spectroscopy measurements show that this limited capacity likely results from the restricted diffusion of Na into the anode nanoparticles and not the formation of a low Na-content phase. Moreover, our results suggest that the η-Cu6Sn5 alloy should have optimized particle sizes of nearly 10 nm diameter to increase the Na capacity significantly. An alternative system consisting of a two-phase mixture of Cu6Sn5 and Sn of nominal composition 'Cu6Sn10' has been studied and is able to deliver a larger initial reversible storage capacity of up to 400 mA h g(-1). Finally, we have demonstrated that the presence of Cu in Cu6Sn5 and 'Cu6Sn10' suppresses the anomalous electrolyte decomposition normally observed for pure Sn.