Mono-layers of aggregated Poly(3-hexylthiophene) (P3HT) and [6,6]-phenyl-C61-butyric acid methyl ester (PCBM) molecules were obtained by using solutions of P3HT, PCBM and P3HT-PCBM mixture without stabilizers such as stearates in chloroform at an air-water interface. 1 to 10 cycle-lifted LB films of P3HT and PCBM were successfully transferred to cleaned bare indium-tin-oxide coated glass substrate by vertical lifting method excluding the first 1 to 2 cycle layer. The dependence of P3HT and PCBM film thickness on the transfer cycles has been explained by the molecular sizes, where four edge-on P3HT molecular and six PCBM molecular stacking which result in thickness was taken into account. Work functions of deposited LB-layers were consistent with those of the ordinary casted films. P3HT and PCBM LB-layers showed optical activity in both infra-red (IR) and visible absorption regions of the spectrum. P-polarized IR absorption owing to C=C and C=O stretching vibrations observed in LB-layered films clearly indicate the enhancement of the orientation of these bonds perpendicular to the substrate surface in contrast to the spin-coated one. Visible optical absorption intensity was increased well in proportion with the lift cycle-numbers of both P3HT and PCBM LB films. The photovoltaic characteristics have been observed in the devices fabricated with P3HT (5 cycles-layer)/PCBM (5 cycles-layer) LB hetero structure as an active layer of the solar cells. The surface pressure of LB compression for the mixture of P3HT and PCBM, that is, bulk hetero mixtures, has also been well built up to 30 mN/m.