The chemical-enhanced washing of Cu2+ or/and phenanthrene (PHE) single or combined contaminated loess soil in Gansu Province was investigated with disodium ethylene diamine tetraacetate (EDTA) or/and sodium dodecyl sulfate (SDS) by the batch equilibrium experiments. The experimental results showed that EDTA or/and SDS could remove efficiently Cu2+ and/or PHE in single-contaminated or combined contaminated loess soils. The Cu2+ removal was significantly promoted by coexisting PHE with low concentration of EDTA (EDTA < 0.1 mol/L), however, the removal was slightly hindered with high concentration of EDTA (EDTA > 0.1 mol/L). As for the PHE removal by EDTA, it was founded that coexisting Cu2+ could enhance the PHE removal in the investigated ranges of the concentrations of EDTA. When concentration of EDTA was 0.01 mol/L, the removal of combined PHE was 20.94% higher than that of single PHE. The experimental results of the removal of contaminations by SDS showed that coexisting Cu2+ could suppress slightly the removal of PHE at a concentration of less than 4 000 mg/L SDS, but could assist the removal of PHE in 5 000 mg/L or higher SDS concentration. On the contrary, the influence of coexisting PHE for the removal of Cu2+ by SDS was that it facilitated Cu2+ extraction by low concentrations of SDS, however, it inhibited the removal of Cu2+ at high concentrations of SDS. The removal efficiencies of PHE and Cu2+ were improved greatly as using combined EDTA-SDS. Beside, there are some differences in the removal efficiency of the oth contaminants with the different sequence of EDTA and SDS added in the washing solution. In EDTA washing followed by SDS, SDS washing followed by EDTA and mixture of SDS-EDTA washing concurrently, the removal of Cu2+ is 91.40%, 95.10% and 96.50%, respectively, which is 28.46%, 32.16%, 33.56% higher than that of combined, 62.94%, by single EDTA. For PHE, the removal is 68.30%, 85.40%, 84.95%, respectively, which is 16.14%, 33.24%, 32. 79% higher than that of combined PHE, 52.16%, by single SDS. Thus, SDS washing followed by EDTA or mixture of SDS-EDTA washing concurrently is considered as the optimal washing sequence for PHE and Cu2+ removal.