Synergistic mercury removal by conventional pollutant control strategies for coal-fired power plants in China

J Air Waste Manag Assoc. 2010 Jun;60(6):722-30. doi: 10.3155/1047-3289.60.6.722.

Abstract

China's 11th 5-yr plan has regulated total sulfur dioxide (SO2) emissions by installing flue gas desulfurization (FGD) devices and shutting down small thermal power units. These control measures will not only significantly reduce the emission of conventional pollutants but also benefit the reduction of mercury emissions from coal-fired power plants. This paper uses the emission factor method to estimate the efficiencies of these measures on mercury emission abatement. From 2005 to 2010, coal consumption in power plants will increase by 59%; however, the mercury emission will only rise from 141 to 155 t, with an increase of 10%. The average emission rate of mercury from coal burning will decrease from 126 mg Hg/t of coal to 87 mg Hg/t of coal. The effects of the three desulfurization measures were assessed and show that wet FGD will play an important role in mercury removal. Mercury emissions in 2015 and 2020 are also projected under different policy scenarios. Under the most probable scenario, the total mercury emission in coal-fired power plants in China will decrease to 130 t by 2020, which will benefit from the rapid installation of fabric filters and selective catalytic reduction.

Publication types

  • Research Support, Non-U.S. Gov't

MeSH terms

  • Air Pollutants / isolation & purification*
  • Air Pollutants / standards
  • Air Pollution / prevention & control*
  • China
  • Coal / analysis
  • Mercury / isolation & purification*
  • Models, Chemical
  • Power Plants
  • Sulfur Dioxide / standards
  • Uncertainty

Substances

  • Air Pollutants
  • Coal
  • Sulfur Dioxide
  • Mercury