The effect of carbide precipitate morphology on fracture toughness in low-tempered steels containing Ni

J Microsc. 2010 Mar;237(3):411-5. doi: 10.1111/j.1365-2818.2009.03275.x.

Abstract

Nickel is known to increase the resistance to cleavage fracture of iron and decrease a ductile-to-brittle transition temperature. The medium-carbon, low-alloy martensitic steels attain the best combination of properties in low-tempered condition, with tempered martensite, retained austenite and transition carbides in the microstructure. This paper is focused on the influence of Ni addition (from 0.35 to 4.00%) on the microstructure and fracture toughness of structural steels after tempering. In this research, four model alloys of different concentration of Ni and constant concentration of carbon and other elements were used. All samples were in as-quenched and tempered conditions. Quenching was performed in oil at room temperature. After quenching, samples were tempered at 200 degrees C for 2 h. The microstructure of the investigated steels was analyzed using JEM200CX transmission electron microscope. An increase of nickel content in the investigated structural steels causes a decrease of epsilon carbide concentration in their microstructure after tempering. In these steels, cementite precipitates independently in the boundaries of martensite needles and in the twin boundaries in the areas where the Fe(2.4)C carbide has been dissolved. These results will be used to design new technologies of tempering of structural steels with nickel addition.

Publication types

  • Research Support, Non-U.S. Gov't