Quadruply bonded dimetal units supported by 2,4,6-triisopropylbenzoates MM(TiPB)(4) (MM = Mo(2), MoW, and W(2)): preparation and photophysical properties

Inorg Chem. 2009 May 18;48(10):4394-9. doi: 10.1021/ic900092c.

Abstract

The preparation and characterization (elemental analysis, (1)H NMR, and cyclic voltammetry) of the new compounds MM(TiPB)(4), where MM = MoW and W(2) and TiPB = 2,4,6-triisopropylbenzoate, are reported. Together with Mo(2)(TiPB)(4), previously reported by Cotton et al. (Inorg. Chem. 2002, 41, 1639), the new compounds have been studied by electronic absorption, steady-state emission, and transient absorption spectroscopy (femtosecond and nanosecond). The compounds show strong absorptions in the visible region of the spectrum that are assigned to MMdelta to arylcarboxylate pi* transitions, (1)MLCT. Each compound also shows luminescence from two excited states, assigned as the (1)MLCT and (3)MMdeltadelta* states. The energy of the emission from the (1)MLCT state follows the energy ordering MM = Mo(2) > MoW > W(2), but the emission from the (3)MMdeltadelta* state follows the inverse order: MM = W(2) > MoW > Mo(2). Evidence is presented to support the view that the lower energy emission in each case arises from the (3)MMdeltadelta* state. Lifetimes of the (1)MLCT states in these systems are approximately 0.4-6 ps, whereas phosphorescence is dependent on the MM center: Mo(2) approximately 40 micros, MoW approximately 30 micros, and W(2) approximately 1 micros.