The effects of fluid and porous media properties on dense nonaqueous phase liquid (DNAPL) migration and associated contaminant mass flux generation were evaluated. Relationships between DNAPL mass and solute mass flux were generated by measuring steady-state mass flux following stepwise injection of perchloroethylene (PCE) into flow chambers packed with homogeneous porous media. The effects of fluid properties including density and interfacial tension (IFT), and media properties including grain size and wettability were evaluated by varying the density contrast and interfacial tension properties between PCE and water, and by varying the porous media mean grain diameter and wettability characteristics. Contaminant mass flux was found to increase as grain size decreased, suggesting enhanced lateral and vertical DNAPL spreading with higher fluid entry pressure. Mass flux showed a slight increase as the DNAPL approached neutral buoyancy, likely due to enhanced vertical spreading above the injection point. DNAPL spatial distribution and contaminant mass flux were only minimally affected by IFT and by intermediate-level wettability changes, but were dramatically affected by wettability reversal. The relationship between DNAPL loading and flux generation became more linear as grain size decreased and density contrast between fluids decreased. These results imply that capillary flow characteristics of the porous media and fluid properties will control mass flux generation from source zones.