Surface EMG alterations induced by underwater recording

J Electromyogr Kinesiol. 2004 Jun;14(3):325-31. doi: 10.1016/j.jelekin.2003.10.002.

Abstract

Background and purpose: This study aims to verify if amplitude and spectral characteristics of surface EMG signal are modified due to recording in a wet environment.

Methods: Isometric contractions of the biceps brachii muscle of ten subjects were performed in several different set-up combinations, both in dry (D) and in water from hydrotherapy pools (PW), with (PWM) or without moving the pool water and with (T) or without water-resistant adhesive taping.

Results: In PW condition the amplitude of the recorded signal is reduced to 5-10% of the corresponding signal recorded in D condition. In PWM the power spectrum is drastically reduced and altered by the water movement that introduces an increase of spectral power in the frequency range 0-20 Hz. The use of T modality allows to record signals with both amplitude and spectral frequencies comparable with those obtained in the D conditions.

Discussion and conclusion: This work demonstrates the need for water resistant taping when EMG signals are recorded in water. Signals recorded without such a protective film are strongly affected in their amplitude and frequency characteristics by the conductivity and the movement of water.

Publication types

  • Clinical Trial
  • Comparative Study
  • Controlled Clinical Trial
  • Research Support, Non-U.S. Gov't
  • Validation Study

MeSH terms

  • Adult
  • Artifacts
  • Bandages*
  • Electrodes*
  • Electromyography / instrumentation*
  • Electromyography / methods
  • Equipment Failure Analysis / methods
  • Humans
  • Immersion*
  • Isometric Contraction / physiology
  • Male
  • Muscle, Skeletal / physiology*
  • Reproducibility of Results
  • Sensitivity and Specificity
  • Water*

Substances

  • Water