On-road measurement of particle emission in the exhaust plume of a diesel passenger car

Environ Sci Technol. 2003 Sep 15;37(18):4070-6. doi: 10.1021/es0300315.

Abstract

Particle size distributions were measured under real world dilution conditions in the exhaust plume of a diesel passenger car closely followed by a mobile laboratory on a high speed test track. Under carefully controlled conditions the exhaust plume was continuously sampled and analyzed inside the mobile laboratory. Exhaust particle size distribution data were recorded together with exhaust gas concentrations, i.e., CO, CO2, and NO(x), and compared to data obtained from the same vehicle tested on a chassis dynamometer. Good agreement was found for the soot mode particles which occurred at a geometric mean diameter of approximately 50 nm and a total particle emission rate of 10(14) particles km(-1). Using 350 ppm high sulfur fuel and the standard oxidation catalyst a bimodal size distribution with a nucleation mode at 10 nm was observed at car velocities of 100 km h(-1) and 120 km h(-1), respectively. Nucleation mode particles were only present if high sulfur fuel was used with the oxidation catalyst installed. This is in agreement with prior work that these particles are of semivolatile nature and originate from the nucleation of sulfates formed inside the catalyst. Temporal effects of the occurrence of nucleation mode particles during steady-state cruising and the dynamical behavior during acceleration and deceleration were investigated.

MeSH terms

  • Air Movements
  • Air Pollutants / analysis*
  • Carbon Dioxide / analysis
  • Carbon Monoxide / analysis
  • Environmental Monitoring / methods*
  • Nitrogen Oxides / analysis
  • Particle Size
  • Sulfur
  • Vehicle Emissions / analysis*

Substances

  • Air Pollutants
  • Nitrogen Oxides
  • Vehicle Emissions
  • Carbon Dioxide
  • Sulfur
  • Carbon Monoxide