In many cases, the link between industrial emissions and damage to the environment can only be inferred. The Environment Agency of the United Kingdom imposes emissions limits on industrial sites so that predicted concentrations and deposition rates remain below standard thresholds. Estimates of appropriate critical levels and loads are usually based on laboratory results and rarely estimate synergistic effects between pollutants or consider biological adaptation or selection in the target receptor organisms. The Avonmouth smelter has been emitting zinc and other heavy metals since 1929. It has been the subject of a number of detailed and synoptic studies, especially the impact on soil invertebrates. Damage was assessed using both physiological and ecological measurements. Two methods of spatial analysis were investigated, namely interpolation using standard geographical information system (GIS) operators and atmospheric dispersal modeling using an off-the-shelf model. Both methods can be used to compute contours (isolines) of predicted biological effect. Correlation results show that dispersal modeling is at least as good as kriging but requires much less data. This article demonstrates the usefulness of GIS and dispersal models as tools in decision making to determine the most suitable sampling sites in the assessment and monitoring of the impact of contamination around major point sources.