Physicochemical and electrochemical characterization of carbon films obtained by pyrolyzing a commercially available photoresist has been performed. Photoresist spin-coated on to a silicon wafer was pyrolyzed at 1,000 degrees C in a reducing atmosphere (95% nitrogen and 5% hydrogen) to produce conducting carbon films. The pyrolyzed photoresist films (PPF) show unusual surface properties compared to other carbon electrodes. The surfaces are nearly atomically smooth with a root-mean-square roughness of <0.5 nm. PPF have a very low background current and oxygen/carbon atomic ratio compared to conventional glassy carbon and show relatively weak adsorption of methylene blue and anthraquinone-2,6-disulfonate. The low oxygen/carbon ratio and the relative stability of PPF indicate that surfaces may be partially hydrogen terminated. The pyrolyzed films were compared to glassy carbon (GC) heat treated under the same conditions as pyrolysis to evaluate the electroanalytical utility of PPF. Heterogeneous electron-transfer kinetics of various redox systems were evaluated. For Ru(NH3)6(3+/2+), Fe(CN)6(3-/4-), and chlorpromazine, fresh PPF surfaces show electron-transfer rates similar to those on GC, but for redox systems such as Fe3+/2+, ascorbic acid, dopamine, and oxygen, the kinetics on PPF are slower. Very weak interactions between the PPF surface and these redox systems lead to their slow electron-transfer kinetics. Electrochemical anodization results in a simultaneous increase in background current, adsorption, and electron-transfer kinetics. The PPF surfaces can be chemically modified via diazonium ion reduction to yield a covalently attached monolayer. Such a modification could help in the preparation of low-cost, high-volume analyte-specific electrodes for diverse electroanalytical applications. Overall, pyrolysis of the photoresist yields an electrode surface with properties similar to a very smooth version of glassy carbon, with some important differences in surface chemistry.