The chemical cleaning method is the simplest approach for degreasing oil-based drilling cuttings (ODCs), with the effectiveness of the treatment relying mainly on the selection of the surfactant and the cleaning conditions. However, achieving the standard treatment of ODCs directly using conventional surfactants proves challenging. In light of this, this study introduces a synthesized and purified Gemini surfactant named DCY-1. The structure of DCY-1 was confirmed through Fourier transform infrared (FTIR) and nuclear magnetic resonance (NMR) analyses. The characterization in this article encompasses the use of an interface tension meter, nanoparticle size analysis, scanning electron microscopy, and infrared oil measurement. The critical micelle concentration (CMC) of DCY-1 was determined to be 3.37 × 10-3 mol/L, with a corresponding γcmc value of 37.97 mN/m. In comparison to conventional surfactants, DCY-1 exhibited a larger micelle size of 4.52 nm, approximately 24.52% larger than that of SDS. Moreover, the residual oil rate of 3.96% achieved by DCY-1 was the lowest among the chemical cleaning experimental results. Through a single-factor experiment, the optimal cleaning ability of DCY-1 for ODCs was determined as follows: a surfactant concentration of 3 mmol/L, a temperature of 60 °C, an ODC/liquid mass ratio of 1:4, a cleaning duration of 40 min, and a stirring speed of 1000 rad/min. Under these optimal conditions and after merely two cleaning procedures, the residual oil content of ODCs was reduced to 1.64%, accompanied by a smooth and loose surface structure.
© 2024 The Authors. Published by American Chemical Society.