Poly(ester imide)s Possessing Low Coefficients of Thermal Expansion and Low Water Absorption (V). Effects of Ester-linked Diamines with Different Lengths and Substituents

A series of ester-linked diamines, with different lengths and substituents, was synthesized to obtain poly(ester imide)s (PEsIs) having improved properties. A substituent-free ester-linked diamine (AB-HQ) was poorly soluble in N-methyl-2-pyrrolidone at room temperature, which forced the need for polyaddition by adding tetracarboxylic dianhydride solid into a hot diamine solution. This procedure enabled the smooth progress of polymerization, however, accompanied by a significant decrease in the molecular weights of poly(amic acid)s (PAAs), particularly when using hydrolytically less stable pyromellitic dianhydride. On the other hand, the incorporation of various substituents (-CH₃, -OCH₃, and phenyl groups) to AB-HQ was highly effective in improving diamine solubility, which enabled the application of the simple polymerization process without the initial heating of the diamine solutions, and led to PAAs with sufficiently high molecular weights. The introduction of bulkier phenyl substituent tends to increase the coefficients of thermal expansion (CTE) of the PEsI films, in contrast to that of the small substituents (-CH₃, -OCH₃). The effects of ester-linked diamines, consisting of longitudinally further extended structures, were also investigated. However, this approach was unsuccessful due to the solubility problems of these diamines. Consequently, the CTE values of the PEsIs, obtained using longitudinally further extended diamines, were not as low as we had expected initially. The effects of substituent bulkiness on the target properties, and the dominant factors for water uptake (W_A) and the coefficients of hygroscopic expansion (CHE), are also discussed in this study. The PEsI derived from methoxy-sustituted AB-HQ analog and 3,3',4,4'-biphenyltetracarboxylic dianhydride achieved well-balanced properties, i.e., a very high T_g (424 °C), a very low CTE (5.6 ppm K^-1), a low W_A (0.41%), a very low CHE value (3.1 ppm/RH%), and sufficient ductility, although the 26 μm-thick film narrowly missed certification of the V-0 standard in the UL-94V test. This PEsI film also displayed a moderate ε_r (3.18) and a low tan δ (3.14 × 10^-3) at 10 GHz under 50% RH and at 23 °C. Thus, this PEsI system is a promising candidate as a novel dielectric substrate material for use in the next generation of high-performance flexible printed circuit boards operating at higher frequencies (≥10 GHz).