Effect of Modifying the Membrane Surface with Microcapsules on the Flow Field for a Cross-Flow Membrane Setup: A CFD Study

In this study, the attachment of microcapsules on the membrane surface and its influence on the flow field for a cross-flow membrane setup are investigated. The microcapsules were placed on the top layer of the membrane. The overall purpose of this modification was the prevention of membrane biofouling. Therefore, in a first step, the influence of such a combination on the fluid flow was investigated using computational fluid dynamics (CFD). Here, different properties, which are discussed as indicators for biofouling in the literature, were considered. In parallel, different fixation strategies for the microcapsules were experimentally tested. Two different methods to add the microcapsules were identified and further investigated. In the first method, the microcapsules are glued to the membrane surface, whereas in the second method, the microcapsules are added during the membrane fabrication. The different membrane modifications were studied and compared using CFD. Therefore, virtual geometries mimicking the real ones were created. An idealized virtual geometry was added to the comparison. Results from the simulation were fed back to the experiments to optimize the combined membrane. For the presented setup, it is shown that the glued configuration provides a lower transmembrane pressure than the configuration where microcapsules are added during fabrication.