Biocatalysts engineering by varying the binary CNTs-silica composition and the physicochemical characteristics of adsorbents for the immobilization of recombinant T. lanuginosus lipase

Biocatalytic engineering was carried out by varying monotonically the binary CNTs-silica composition and, accordingly, the physicochemical characteristics of adsorbents developed for immobilization of recombinant T. lanuginosus lipase (rPichia/lip). The adsorbents based on composite carbon-silica materials (CCSMs) were produced by impregnating finely dispersed multi-walled carbon nanotubes with silica hydrosol followed by calcination in argon at 350°C; the mass ratio of the hydrophobic and the hydrophilic components varied over a wide range. Biocatalysts (BCs) for green low-temperature synthesis of various esters in a non-aqueous medium of organic solvents were prepared by adsorption of rPichia/lip with subsequent drying under ambient conditions. The characteristics of the CCSMs and BCs were characterized by thermogravimetry, nitrogen porosimetry and electron microscopy. The catalytic properties of BCs, such as enzymatic activity, substrate conversion and specificity, as well we their operational stability depending on the chemical composition of CCSMs were extensively studied in the esterification of saturated monocarboxylic acids (C₄, C₇, C₁₈) and primary aliphatic alcohols (C₂, C₄, C₁₆) in hexane at 20°C. It was found that the esterifying activity manyfold decreased with increasing the silica content primarily due to a decrease in adsorption ability of CCSMs toward rPichia/lip. The substrate specificity and operational stability of the lipase-active BCs did not greatly depend on the composition of CCSMs. Biocatalysts retained more than half of their initial esterifying activity after 10 reaction cycles.