In vitro and animal experiments have shown that the severity of coronary stenoses can be assessed using the continuity equation if the maximal blood flow velocity of the stenotic jet is measured. The large diameter and the low range of velocities measurable without frequency aliasing with the conventional intracoronary Doppler catheters precluded the clinical application of this method for hemodynamically significant coronary stenoses in humans. This article reports the results obtained using a 12 MHz steerable angioplasty guidewire in a consecutive series of 52 patients undergoing percutaneous coronary angioplasty (61 coronary stenoses). The ratio between coronary flow velocity in a reference segment and in the stenosis was used to estimate the percent cross-sectional area stenosis. A Doppler recording suitable for quantitation was obtained in the stenotic segment in only 10 of 61 arteries (16%). The time-averaged peak velocity increased from 15 +/- 5 to 115 +/- 26 cm/sec from the reference normal segment to the stenosis. Volumetric coronary flow calculated from the product of mean flow velocity and cross-sectional area was similar in the stenosis and in the reference segment (33.2 +/- 14.9 vs 33.5 +/- 17.0 mL/min, respectively, difference not significant). The percent cross-sectional area stenosis and minimal luminal cross-sectional area derived from the Doppler velocity measurements using the continuity equation and calculated with quantitative angiography were also similar (Doppler, 86.7 +/- 5.1% and 1.00 +/- 0.48 mm2; quantitative angiography, 85.9 +/- 7.9% and 1.02 +/- 0.50 mm2).(ABSTRACT TRUNCATED AT 250 WORDS)